“Many MacRumors readers were concerned about Apple’s position that a noticeable bend is not a manufacturing issue, prompting MacRumors reader Craig to send an email to Apple CEO Tim Cook to express his concerns,” Clover reports. “While Cook didn’t respond, Craig did get a reply from Apple’s VP of hardware engineering, Dan Riccio…”
Relative to the issue you referenced regarding the new iPad Pro, its unibody design meets or exceeds all of Apple’s high quality standards of design and precision manufacturing. We’ve carefully engineered it and every part of the manufacturing process is precisely measured and controlled.
Our current specification for iPad Pro flatness is up to 400 microns which is even tighter than previous generations. This 400 micron variance is less than half a millimeter (or the width of fewer than four sheets of paper at most) and this level of flatness won’t change during normal use over the lifetime of the product. Note, these slight variations do not affect the function of the device in any way.
Again, thanks for reaching out and I hope the above explanation addresses your concerns. — Dan Riccio, Apple’s Senior Vice President of Hardware Engineering
Warped iPad Pro image via MacRumors with red lines overlay by MacDailyNews
Read more in the full article here.
MacDailyNews Take: The photos we’ve seen are of units that are warped noticeably more than four sheets of paper. If your iPad Pro is warped over 400 microns in variance, take/send it back to Apple and ask for a replacement.
SEE ALSO:
Apple says some 2018 iPad Pro units ship with bent chassis, but they don’t consider it a defect – December 20, 2018